Shower room installation takes 12 steps to create a safe shower environment

Most of the sanitary products we buy need to be installed. The quality of the installation directly affects our future use. I believe that everyone attaches great importance to the installation of the shower room, especially its safety and self-destruction is inseparable from the installation operation. The angle and strength of the installation of the shower room are not controlled by ordinary people. Therefore, when installing, be sure to find an experienced person to install. The following small series will tell you about the installation of the shower room. I hope everyone can understand .

Step 1: Check that the packaging is intact before loading and prepare the tools you need to use.

Step 2: Assemble the bottom part, adjust the level, and connect the hose to the floor drain.

Step 3: Perform a water pouring experiment to see if the water is fast and unobstructed.

Step 4: Find a good position on the wall with a pencil and a level ruler and start punching with a hammer drill.

Step 5: Install the aluminum material, knock the rubber particles into the hole, lock the aluminum strip to the wall with screws, and adjust the position to ensure the verticality of the aluminum.

Step 6: Firstly clamp the glass to the bottom hole of the bottom basin, place the tempered glass in the glass clamp slot, push it into the wall aluminum and fix it with screws.

Step 7: Find the fixed seat position, punch the hole, install the fixed seat, and connect the top tube.

Step 8: There is a rack in the shower room. At this time, the rack should be installed, mainly to maintain the vertical and horizontal of the glass partition.

Step 9: Install the swing door, the hardware mounting hole is left on the glass, and the lock should be adjusted to the proper tension. The switch is most comfortable.

Step 10: Install a strip with water-blocking effect on the side and bottom of the glass, and seal the gaps with silicone.

Step 11: Final commissioning of the entire shower room and each hardware accessory.

Step 12: Install the decorative aluminum strip and clean the inside of the shower room.

Grab Bar

Grab Bar,Grab Bar For Disabled,Plastic Grab Bar,Hospital Grab Bar

NINGBO AIKEHAN METAL PRODUCT CO.,LTD , http://www.diecastingsupplier.com