The wooden door takes a long time, and everyone will be happy and tired. Because of the long time, there will naturally be many traces of bumps and bumps, making people look unsatisfied and uncomfortable. Here are the seven tricks to teach the old mahogany door to be reborn:
The first trick to repair the paint surface: If the wax oil is accidentally dropped on the wooden door paint surface, do not use sharp edges or nails to scrape. Wait until the daytime light is good, use plastic sheets, hold hands tightly, tilt forward, wax The oil is slowly scraped from the front of the body, and then wiped with a fine cloth; if the painted surface of the wooden door is scratched, the crayon or pigment that matches the color of the wooden door can be used to wipe the wound on the wooden door, cover the exposed ground color, and then use transparent Apply a thin layer of nail polish. If the wooden door finish is damaged by burning, apply a fine-grained hard cloth to the toothpick, gently wipe the traces, and then apply a thin layer of wax to remove the scorch marks.
The second move to repair the dent: Some wooden doors are soft because of the wood, leaving a dent after the collision. At this time, you can use a wet towel to place it in the depression, and then iron it with an iron to restore it. If the dent is deep, add a filler.
The third measure repairs cracks: If the solid wood door cracks due to heat and cold shrinkage, the following remedial measures can be taken; the old cotton cloth or broken sack is burned to ash, and then mixed with raw tung oil into a paste, embedded in the crack of the wood, After the shade is dry, it can be filled and glued.
The fourth step is to raise the surface of the wooden door: after the decorative veneer is bubbling, you can use a sharp blade to cut a knife in the middle of the bubble in the direction of the wood grain, then use a syringe to inject the glue into the slit and gently press it with the finger. In the upper part, the overflowed glue is cleaned with a damp cloth, and a weight with a smooth bottom surface and larger than the bubbling area is pressed thereon. In order to prevent a small amount of glue from overflowing and sticking to the peripheral surface of the bubbling after the pressurization, the plastic film may be covered on the bubble so that the decorative veneer is flat.
The fifth move eliminates water marks: Water drops on the wooden door, if not dried immediately, will leave traces of water stains. At this time, cover the trace with a damp cloth, and then carefully press the wet cloth several times with an electric iron. The moisture of the trace will evaporate with heat, and the water mark can be eliminated. [Follow the WeChat public number "Jiuzhengmen window network: jiuzhengmenchuang"; pay attention to courtesy, scan code to send millions of business opportunities! Jiuzhengmen window network exchange group]
Hesso barrier also know as rock basket retaining wall, Hesco Barrier, flood control barrier, etc. which is made of the steel welded mesh and lined with non-woven geotextile , can be filled with sand, earth, cement, stone, then as a defence wall or bunker and widely used in the military to protect safety .
Hesco barrier is a modern gabion primarily used for flood control and military fortifications. It is made of a collapsible wire mesh container and heavy duty fabric liner, and used as a temporary to semi-permanent levee or blast wall against explosions or small-arms.
Hesco Barrier
Hesco Barrier,Hot Dipped Hesco Barrier,Galvanzied Hesco Barrier
Hebei Giant Metal Technology Co., Ltd. , https://www.wiremesh.pl