In our warm home, have you done your home care? How to buy and use tableware is safe enough? Did the furniture, walls, etc. suffer from minor "injuries" and knew how to treat them "injury"? Taking good care of your home is like taking care of your family. It requires careful, careful and careful attention!
Carefully take care of the wall
The problem of "face" must be prescribed
The wall is the "face project" in the home and it is also the most vulnerable place. Large and small cracks in the wall, the wall near the heater were smoked, etc., are all common "walls". When these problems are encountered, they must not be ignored and must be carefully repaired.
Problem I: Cracking
Local cracking also exists in a variety of situations, such as structural cracking of the original wall, cracking of the wall after dampening, unsuitable cracking of the original primary layer, cracking between the new wall and the original wall.
Treatment process: local patch treatment. If the gap is large, you can first attach kraft paper, then use Dacron cloth to make a primer, brush the interface agent, and then scrape 2-3 times wall lining or waterproof putty, and finally brush the primer and 2-3 times of topcoat again.
Question 2: Drums
Partial drumming is mainly due to moisture, the adhesive surface is not solid or the sand and aging of the original structure wall cause druming.
Treatment process: Partially removed to the cement layer, brush the interface agent, scrape 2-3 times wall lining or waterproof putty, and then brush the primer again and 2-3 times of topcoat.
Question 3: Injustice
If there is a large wall undulation, the wall needs to be leveled first.
Treatment process: If the wall undulation is less than 1.5 cm, leveling gypsum can be used to level; 2 cm above the leveling with cement mortar; if the top corner if the error is too large, you can plaster the line for aesthetic treatment; if the wall of the Yin angle greater error Use plaster for leveling and then brush putty, paint, etc.
Question 4: From the skin
There are three main reasons for the wall paint peeling, one is the dampness of the room; the other is that the original foundation is not solid enough for construction; another is that the construction process is not correct, and the wall paint is not peeled off in strict accordance with the process flow and specification.
Treatment process: The part needs to be removed to the cement layer, brush the interface agent, and then scrape 2-3 times wall lining or waterproof putty, and then brush the primer again and 2-3 times the top coat.
Intensive healing for furniture
Furniture abrasion can be filled with special color correction agent
In everyday life, furniture is often accidentally "injured" due to various unexpected conditions, such as the cigarette butt burned the table or the cabinet door is deformed. How can we help the furniture successfully treat "injury"? There are many repair tips on the Internet. Are they applicable? Listen to experts how to say.
Color yellow or obsolete
Network statement: use toothpaste (or toothpaste) to wipe, can be changed.
Expert opinion: This is the "yellowing" phenomenon caused by the oxidation reaction of paints and curing agents. Generally it turns yellow from inside to outside, and white and light-colored furniture are prone to this situation. Although the dentifrice (or toothpaste) has a certain ability to decontaminate, its fine wear-resistant particles can also wipe off the stains attached to the furniture surface, but it has no effect on the paint film that has undergone yellowing, and can only be re-painted after sanding.
Deformation of the door
According to the Internet, pressing a door panel with a flat weight can make a big difference.
Expert opinion: Deformation of panel furniture mainly includes distortion caused by unsatisfactory production quality, and deformation caused by moisture-swelling without handling. Deformation of solid wood furniture is mainly due to the high moisture content of the wood. After the water evaporates, the wood shrinks unevenly. When the paint is sprayed, the surface is unevenly sprayed inside and outside. The thickness of the coating is different, resulting in a difference in water absorption and deformation.
If it is the reason of the material itself, it can only be returned to the factory or removed and replaced. If the paint is uneven, repainting is required. The use of heavy objects to press a pressure is only an expedient measure.
Furniture surface scratches
Network statement: Use a crayon or paint that matches the color of the furniture, apply it to the wound surface of the furniture, cover the exposed background color, and apply a thin layer of transparent nail polish.
Expert opinion: The above approach is only an expedient measure. The scratch is a "ditch" on the surface and should be repaired with a special color repair agent, "make up the soil", and then a layer of varnish. Panel furniture is scratched and can be repaired using a crayon similar to the melamine board and sprayed with a varnish. Nail polish hardness is not enough and is not recommended.
Burn marks or scald white marks
Network statement: Burning materials such as cigarettes, soot, or unlit matches sometimes leave scars on the furniture finish. If only the paint is burning, put a thin hard cloth on the toothpick, gently wipe the traces, and then apply a thin layer of wax to remove the burn marks. If burnt paint under the wood, this law is powerless.
Inadvertently put hot water cups on wooden furniture, the surface of the paint will appear a circle of white hot marks, you can paint Vaseline oil on top, two days later, gently wipe with a soft skin, hot marks can be removed.
Expert opinion: Both of the above methods have no effect. Dealing with burn marks can only excavate the charred part, and then use "supplement" to make up, repair the wood grain, and paint the paint. If the lacquer furniture produces scald white marks, it indicates that the dry heat resistance of the paint is unqualified because the chemical substances in the paint are reacted in the paint film after being exposed to high temperatures, resulting in water vapor and white fog that looks like. The use of Vaseline in the above is probably to use Vaseline to absorb water, but this method is not effective. The expediency plan is to repair it with a color repair agent and paint it. If you want to completely solve the film can only be destroyed, re-painted with dry heat resistant paint.
Carefully care for tableware
Minimize the use of porcelain dishes in microwave ovens
A few days ago, AQSIQ issued an emergency notice to target some lawbreakers to use urea-formaldehyde resin that does not meet the requirements of the national standard to produce melamine tableware. The request is for a nationwide enforcement of production and processing of melamine tableware from now until May 15. an examination. According to experts, urea-formaldehyde resins are dissolved in water at relatively high temperatures and produce formaldehyde, which is a recognized carcinogen. AQSIQ experts believe that as long as it is not used in ultra-high temperature environments, qualified porcelain tableware can be used with confidence.
Today, the tableware on the market is dazzling, imitation porcelain, bone china, reinforced porcelain, and white porcelain. How do consumers identify and use it correctly?
Imitation porcelain tableware: safer in white or light colors
Imitation porcelain tableware is also called melamine tableware. It is a new type of tableware widely used in restaurants and homes. The melamine tableware was immersed in boiling water for 30 minutes, then removed, and left at room temperature for 1 hour. This was repeated 3 times. In the experiment, the cutlery appeared white, astringent, blistering, cracking, and a pungent odor. Explain the quality of the melamine tableware.
The real melamine resin is white, and now the colorful melamine tableware on the market is colored, soaked in water, or when high temperature foods are served, the formaldehyde or pigment in the inferior tableware may "run out" and be issued. A pungent odor or faded white appearance. Zhao Xiaofeng, general manager of Shi Jieyi, said that consumers can't discern with the naked eye, so it's best to choose white or light colors when buying melamine-ware.
Bone China Tableware: Wash with mild detergent
The bone china products have 30% of the internal materials of tricalcium phosphate in the animal bones, so the surface of the bone china is bright and clean, and it is jade. According to Gao Lijun, the person in charge of the Yashen Bone Porcelain in Daming Palace Building Materials Home City, apart from the smooth glaze, elegant painting, and hard texture, a good bone china product has a method of identification. After the lap, the bowl will make a distant sound and it can be heard twenty meters away, and poor quality products will not make a sound at all.
Gao Lijun also reminded consumers that the general set of bone china is a high-end tableware, so when cleaning, it is best to use a mild detergent or sponge, towel cloth wipe, rough scouring pad or with corrosion Sexual cleansers can damage the decals on the product. At the same time, use dishwashers as little as possible because collisions tend to damage the pattern.
Reinforced porcelain tableware: go to regular shopping malls
The most common and relatively modest price in the market is reinforced porcelain and white porcelain dishes. The gloss and transparency of reinforced porcelain are not as good as those of bone china, but due to its moderate price, it has high strength and is resistant to acid and alkali. Because ceramics contain lead components, long-term use of inferior tableware will cause harm to the human body, so it is best not to buy on the roadside or on the street, but to go to regular shopping malls.
According to Kaiyuan Mall’s personnel responsible for sales of porcelain, the newly purchased cutlery can be soaked and sterilized with edible vinegar prior to use; utensils with metallic moldings and pattern colors should not be placed in microwave ovens. When washing, add detergent with warm water, wipe with a sponge or a soft cloth, rinse with water, and wipe clean with a soft towel. Do not scrub with a rough brush or cleaning cloth to avoid damaging the glaze of the tableware and causing scratches.
Wall construction paint furniture formaldehyde home cement white furniture painted furniture plate furniture painted wall cabinet door
Home Decoration,Glass Teapot,Glass Jar Co., Ltd. , http://www.glass-candleholder.com